Top Ten Tech Tips

    Tech Tips Blog

     All Posts

    Tech Tip #57 : Supplementary Obtuse Angle

    Posted by Cecil Deline on Wed, Sep 06, 2017 @ 04:34 PM

    Reviewing the NEW enhancement allowing the option to report the Supplementary Obtuse Angle when programming Angle Between from the 'Tolerance' ribbon. Requires CheckMate 14.0.00734 for SOLIDWORKS® or newer.

    Read More
    0 Comments Click here to read/write comments

    Topics: origin international, measurement, metrology, CheckMate for SOLIDWORKS

    Tech Tip #56 : Circle Measurements In a Cone

    Posted by Cecil Deline on Wed, Sep 06, 2017 @ 04:25 PM

    Reviewing the procedure to put a circle measurement inside cone geometry. Requires CheckMate 14.0.00734 for SOLIDWORKS® or newer. 

    Read More
    0 Comments Click here to read/write comments

    Topics: origin international, measurement, metrology, CheckMate for SOLIDWORKS

    Origin Tech Tip: Initial settings in CheckMate for SOLIDWORKS®

    Posted by Janet Wiaderny on Mon, Jul 28, 2014 @ 04:54 PM

    Reviewing some initial settings when firing up CheckMate for SOLIDWORKS® for the first time.

    Read More
    0 Comments Click here to read/write comments

    Topics: origin international, SolidWorks, CheckMate, metrology

    Origin Tech Tip: Setup two windows for comparing

    Posted by Janet Wiaderny on Mon, Jul 28, 2014 @ 04:46 PM

    Reviewing how to setup two windows in Origin's CheckMate when you are comparing two dwg files, using the WINDOWS menu. (syswindows command)

    Read More
    0 Comments Click here to read/write comments

    Topics: origin international, CheckMate, metrology

    Origin Tech Tip: Drag measurement hits to new locations

    Posted by Janet Wiaderny on Wed, Jan 30, 2013 @ 02:46 PM

    Procedure to drag measurement hits to new locations

    Read More
    0 Comments Click here to read/write comments

    Topics: origin international, measurement, metrology

    Origin Tech Tip: How to enable easy label updates ...

    Posted by Janet Wiaderny on Tue, Oct 16, 2012 @ 12:54 PM

     

     

     

    Origin Tech Tip: We will be reviewing a couple switches, that when enabled. allow for easy updating of labels when editing measurements.

    Read More
    0 Comments Click here to read/write comments

    Topics: measurement, metrology, Origin

    All posts