Top Ten Tech Tips

    Tech Tips Blog

     All Posts

    Tech Tip #56 : Circle Measurements In a Cone

    Posted by Cecil Deline on Wed, Sep 06, 2017 @ 04:25 PM

    Reviewing the procedure to put a circle measurement inside cone geometry. Requires CheckMate 14.0.00734 for SOLIDWORKS® or newer. 

    Read More
    0 Comments Click here to read/write comments

    Topics: origin international, measurement, metrology, CheckMate for SOLIDWORKS

    Tech Tip #51: Converting Measurements

    Posted by Cecil Deline on Wed, Dec 21, 2016 @ 04:14 PM

    Reviewing the use of the CONVERT and CONVERT WITH CONSTRUCTION commands, in CheckMate for SOLIDWORKS®.

    Read More
    0 Comments Click here to read/write comments

    Topics: origin international, measurement, Origin, CheckMate for SOLIDWORKS

    Origin Tech Tip: Drag measurement hits to new locations

    Posted by Janet Wiaderny on Wed, Jan 30, 2013 @ 02:46 PM

    Procedure to drag measurement hits to new locations

    Read More
    0 Comments Click here to read/write comments

    Topics: origin international, measurement, metrology

    Origin Tech Tip: Review one of our new commands

    Posted by Janet Wiaderny on Wed, Oct 17, 2012 @ 10:15 AM

     

    Read More
    0 Comments Click here to read/write comments

    Topics: CheckMate, measurement, Origin, condense

    Origin Tech Tip: Creating CAD sections

    Posted by Janet Wiaderny on Wed, Oct 17, 2012 @ 09:53 AM

    Origin Tech Tip: This tech tip reviews creating CAD sections. Either using the CAD 'amsection' command or using CheckMate's Autosection to generate measurements and CAD sections simultaneously.

    Read More
    0 Comments Click here to read/write comments

    Topics: measurement, Origin, CAD sections

    Origin Tech Tip: How to create a surface measurement ...

    Posted by Janet Wiaderny on Tue, Oct 16, 2012 @ 01:23 PM

    Origin Tech Tip: Watch Cecil in action as he shows how to create a CheckMate surface measurement in the center of a hole.

    Read More
    0 Comments Click here to read/write comments

    Topics: CheckMate, measurement, Origin

    Origin Tech Tip: Create "ordered" trim measurement ...

    Posted by Janet Wiaderny on Tue, Oct 16, 2012 @ 12:57 PM

     

    Read More
    0 Comments Click here to read/write comments

    Topics: CheckMate, measurement, Origin

    Origin Tech Tip: How to enable easy label updates ...

    Posted by Janet Wiaderny on Tue, Oct 16, 2012 @ 12:54 PM

     

     

     

    Origin Tech Tip: We will be reviewing a couple switches, that when enabled. allow for easy updating of labels when editing measurements.

    Read More
    0 Comments Click here to read/write comments

    Topics: measurement, metrology, Origin

    All posts